BURANO ACERO Electric Focal Point Fire Instructions for use Please retain for future reference De’Longhi; February 2004 Issue 3
Thank you for choosing to purchase a De’Longhi fire. Please read the instructions carefully in order to enjoy your product fully. GENERAL INSTRUCTIONS Remove the fire from the packaging, checking that neither the fire nor the power cable has been damaged during transport. Do not operate the fire if damaged. The pebbles can be found in one of the two long brown boxes that fit down either side of the fire, so ensure that the accessories are removed before discarding the boxes.
OPERATING THE FIRE Controls The on/off push button switch is located on the top right hand side of the fire. Pushed in, it will illuminate the fire with no heat, so that you may enjoy the flame effect all year round. Pushed again the switch will return to its outer position and turn the fire off. To use the heating element (the heater element is under the hood), press the button marked with one red bar. The fire is 2kW and is thermostatically controlled. The thermostat is positioned nest to the heat switch.
PROBLEM SOLVING No power to the fire No Illumination / flame effect Heater cuts out / poor or no flame effect Outer frame sits away from fire on delivery Fitting of the spacer frame Check the wall socket and plug and fuse Check that fire is switched on. Check that the bulbs are working. Check that the chimney is blocked off above the fire There is a normal tolerance of 2mm to 6mm where the outer frame sits around the fire.