Use and Care Manual

Installation

Installing the solar panel

NOTE: Do not use a hammer. If the ground is hard, use

water to soften.

□ To mount the solar box (A) to the ground, insert the ground

stake (E) firmly into the ground at the installation location.

If the ground is too hard, soak the ground with water to

soften the ground or drive a metal rod or screwdriver into

the ground to create a hole for the ground stake assembly.

□ Connect the pole (D) to the ground stake (E).

□ Slide the pole connector (C) into the mounting slot on the

back of the solar box (A).

□ Connect the installed pole connector (C) on the solar box (A)

to the pole (D).

□ To mount the solar box (A) to a wood surface such as fence

or wood post. Using the two mounting screws (AA) provided

to secure the wall mounting bracket (F) to the mounting surface.

□ To mount the solar box (A) to a wall broad or brick walls, drill

two 7/32 in. holes into the wall surface and insert the two wall

anchors (BB). Using the two mounting screws (AA) provided

to secure the wall mounting bracket (F) to the mounting surface.

□ Slide the top plate of the wall mounting bracket (F) into the

mounting slot on the back of the solar box (A). Adjust the solar

panel to the desired angle to optimize sun exposure.

Installing the string light

IMPORTANT: To reduce the risk of damage to the fragile glass

light bulbs, do not install this string light at the location where the

light bulb has the possibility of impacting on the hard objects

during the strong wind blowing.

IMPORTANT: Prior to use, set the ON/OFF switch located on the

back of the solar box (A) to the ON position and allow it to charge

a full sunny day.

NOTE: Replacement light bulb Model 82052-010LB is available at

www.creative-prc.us or by emailing CustomerService@Creative-

prc.us. Do not buy any random replacement light bulbs and try to

use on our string light.

1. To install your string light to a pavilion or the space between trees,

feed a guide wire (not included) through the build-in loops of each

lamp holder. Secure the guide wire to the pavilion or the trees to

hang the light string along the guide wire.

2. To install your string light to a tree or an umbrella, using the flexible

string (not included) or the S hook (not included) to hang each lamp

holder onto the tree branches or the umbrella skeletons.

3. To install your string light to a deck rail, twist the light string around

the railing directly. After you install the light string, screw the light bulbs

(B) counterclockwise into the lamp holders.