Assembly Instructions

Page 6 | v.4 | DF4 DECKED. COM | #DECKEDUSA | @DECKEDUSA
TAILGATE AMMO CAN AXLE CABSIDE AMMO CAN VERT AXLE CCHANNEL ENDPLATE
CS AMMO CANS
B1
B1
CCHANNEL HW
ASSEMBLY: DRIVER’S SIDE DECK
(LET’S DO THIS!)
• There are three pre-installed gaskets – one on the center vert, one on each underside of the decks where they rest
on the center vert. Do yours look weird? See them here: DECKED.COM/GASKETS
• Place C-channel on the inside ledges of a cabside ammo can and a tailgate ammo can.
• The end of the C-channel with the endplate must rest on the cabside ammo can.
• Verify that the tailgate ammo can’s axle is closest to the tailgate; if not, grab the other tailgate ammo can.
• Loosely bolt C-channel to the two ammo cans. Make sure the bolt head is on the C-channel side, not inside the
ammo can; BAG CCHANNEL HW. Don’t tighten yet.
• Line up the driver’s side deck (sticker on end of deck panel indicates LEFT/DRIVER) on top of the
C-channel/ammo can assembly and the center vert bosses. NOTE: Tailgate side of the center vert has an axle
installed; the center vert and ammo can axles must be on the tailgate end (not cabside end) of the assembly.
• Bolt the deck to the ammo cans; BAG B1 for the tailgate ammo can, BAG CS AMMO CAN for the cabside ammo can, but
do not install any bolts in the two holes along the cabside edge of the ammo can–leave these empty for now
(see INSTALL page 8, for reference).
• Now go back and tighten the loose bolts connecting the ammo cans to the C-channel.
• Bolt the deck to the center vert; BAG B1: Do not use power tools!
• Grab your buddy to help you lift the assembly into the driver side of the truck bed.
DRIVER SIDE
DECK HALF
➡
CAB