Installation Guide

stair bracket as a guide, mark the screw positions on the post sleeve and rail on
both ends. Pre-drill 1/8" pilot holes through the post sleeve and rail. Attach the
stair bracket to the post sleeve using the #8-15 x 2" - #2 square drive flat head
screws and then attach stair bracket to rail using #8-16 x ¾" - #1 square drive
wafer head self-drilling screws.
Step 10 Slide the rail bracket cover over the rail bracket and snap into place.
Step 11 Apply a thin line of clear exterior construction adhesive to the inside
rim of a post cap and place firmly on the post. Repeat for each post.
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR USE
OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE CONSTRUCTION
OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT, INCLUDING, BUT NOT
LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY,
EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
©2018 Universal Forest Products. Deckorators is a registered trademark of Universal Consumer Products, Inc. in the U.S. All rights reserved.
1801 E. Lessard St. Prairie du Chein, WI 53821
10332 11/18
www.lowes.com
Baluster
Bottom Rail
•
BottomStairRail.pdf
•
fig. 10