Specification Sheet
© DECO LAV, INC. 2016
2
PLEASE CONTACT 1-866-DECOLAV (332-6528) FOR FURTHER ASSISTANCE
DECOLAV.COM
ASSEMBLY INSTRUCTIONS
• Prior to installation, unpack your new DECOLAV® product and inspect it.
Keep the product in its original package until you are ready to install it
• Shut the water supply off when replacing an existing xture
• Observe all local plumbing and building codes
• It is recommended that this installation be done with a minimum
of two people. Do not install this xture alone.
• Afx provided template to countertop at desired location
• Mark guidelines on countertop in several places
• Drill a clearance hole approximately ¼” to ½” inside the
perimeter line of the template
• Cut opening following the perimeter line of template
• Check for cutout alignment by placing lavatory in desired
mounting position
• Refer to mounting clips detail. (Recommended for installation using
countertops with a minimum thickness of 1” (25 mm). Installer must
supply anchors for thinner countertops)
• Drill anchors hole 3/8” diameter x 1/2” deep. Apply small amount
of epoxy (not provided) to closed end of threaded knurl. Insert
threaded knurl (threaded open end exposed)
• Apply sealant around the topside (rim) of lavatory near the edge,
as shown
• Carefully raise lavatory in place. Align and press rmly to set
• Wipe off excess sealant
• Attach undermount clips to hold lavatory in place.
NOTE: FOR WOOD COUNTERTOPS USE WOOD SCREWS
AND ANCHORS, WOOD SCREWS NOT PROVIDED
• Allow sealant to set before proceeding to install drain,
waste system, faucet and water supply according
to manufacturer’s installation instructions.
NOTE: DO NOT OVER TIGHTEN THE DRAIN.
MAY RESULT IN DAMAGE
• Check for leakage
BEFORE YOU BEGIN
UTILIZING THE CUTOUT TEMPLATE
INSTALLING YOUR UNDERMOUNT LAVATORY
1
2
NOTE: Use DECOLAV
®
decorative bottle trap item #
9102-CP/SN/PN to complete your new look.
NOTE: Use DECOLAV
®
drain item # 9295-CP/SN/PN, or
# 9297-CP/SN/PN. DECOLAV
®
cannot guarantee against
leakage with other manufacturer drains.
Figure 1
Figure 2
1839-24-SSA
Item # 1839-24-SSA
Threaded Knurl
Mounting Clip
Washer
Machine Screw
Apply
sealant
here