Owner manual

JORDAN MODULAR SERIES
Customer Service: 561-274-2110
www.decolav.com
LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS
®
4
INSTALLING THE VANITY
o If a Vanity drawer or a Drawer console is to be hooked to the vanity skip to the hook up sections on
Page 5 and 6. Follow hook up steps. Once Vanity hookup is complete follow Vanity installation
instructions.
o Carefully remove vanity from carton and place safely aside.
o Turn o water supply to faucet.
o Remove existing vanity.
o Determine the location on the wall where the vanity will be installed.
o Measure the vanity width and height and mark outline on wall.
Notes:
o We recommend two people to install this vanity
Figure B
STEP #2
o Measure and mark the locations of the plumbing pipes and lines
o Make a cutout in the back panel of the vanity using a circular saw or saber saw, allow enough room for
the plumbing lines and pipes to pass through.
o Drill 2, 3/16” diameter holes in the vanity back rail. These holes will be used to connect the vanity to the
wall using wall anchors or screws (not included).
o Carefully Position the vanity in the desired location.
o Level the vanity side to side and front to back using a carpenter’s level and adjust the leg levelers. The leg
levelers are located at the bottom of each leg.
o Attach vanity to wall using wall anchors or screws (not included).
Customer to make cutout
in vanity back panel
Customer to bore holes in
the back rail for attching the
vanity to the wall.
Figure A
Hookup Hardware Included with the Vanity Drawer and the Drawer Console
Note: Hookup Hardware is Only Provided with the Vanity Drawer and the Drawer Console. No Hookup
Hardware is Provided with the Vanities.
STEP #1
Item Desription QTY
A Connecting Bolt (Included with Drawer Console and Vanity Drawer) 4
B Flat Washer (Included with Drawer Console and Vanity Drawer) 4
C Connecting Wood Screw (Included with Drawer console and Vanity
Drawer
6
D T-nut (Included with Drawer Console and Vanity Drawer) 4
E Small T nut screw (included with Drawer console and Vanity Drawer) 12
F Insert Nut, Factory installed on Support Leg 2
A
BC
DEF