Owner manual

JORDAN MODULAR SERIES
Customer Service: 561-274-2110
www.decolav.com
LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS
®
9
INSTALLING THE TOP TO THE VANITY
o With the vanity in the desired location Place a small bead of silicone to the areas shown in Figure G.
o Carefully lower top into position. There will be approximately 1/4 inch of top overhang on either side of
the top. Back of top should be aginst the wall
o Apply a bead of silicone to the bottom edge of the backsplash and to the back of the backsplash.
Apply backsplash to the back of the vanity top and the wall.
o Let Silicone Cure per manufactures speci cation before using.
Step #1
Use Silicone on the Bottom and the
Back Edge of the Backsplash
Apply a Small Amount of Silicone to the
areas shown
INSTALLING THE TOP ON THE VANITY CONSOLE/ VANITY DRAWER
o Apply a small amount of Silicone to the areas shown. Figure I
o Because of the decorative moulding that is directlly below the Vanity top the Drawer Console top and the
Vanity drawer top must be slid in from the front. See Figure I
o The back edge of the Vanity drawer and Drawer Console should be  ush with the back of the Vanity Drawer
chassis and the back of the Drawer console Chassis
Step #1
Drawer Console
Apply a Small Amount of Silcone
to the areas shown
Figure I
Vanity
Vanity Top
Backsplash
Figure H
Apply a Small Amount of Silcone
to the areas shown
Vanity Drawer Top
Vanity Drawer
Drawer Console Top