Owner`s manual

Blinking indicates SETUP mode. SETUP is explained on page 5.
94
When the INVERT LED is On (solid green), the Freedom Inverter is inverting (making AC power from the DC battery source). When the INVERT LED is Off, the inverter is Off.
When external AC power is present (AC IN LED On) and the INVERT LED is blinking green, the inverter is in standby, waiting for external AC power to be removed to begin inverting. When there is no external AC power, a blinking green LED indicates the inverter is in the Idle Mode. Idle mode is explained in detail in the SETUP section. OPERATING TIP: To avoid the risk of discharging your batteries if external power fails, leave the inverter OFF when leaving the boat or RV unattended.
INVERT
SETUP
external AC power is detected. OPERATING TIP: Leaving the charger ON helps to assure a full battery.
When the CHARGE LED is On (solid green), the Battery Charger is On and charging. When the LED is Off, the charger is Off. Charging automatically begins when
CHARGE
REMOTE POWER SHARE USED BY FREEDOM (SN < 100,000) POWER MODEL: F10 F20 F25 F25 SHARE SN: <100,000 <70699 <70801 >70802 50 NA NA OFF OFF 30 30 30 NA NA 20 20 20 50 30 15 15 15 30 20 5 10 10 20 5
plug into a 30 ampere external AC power source, press POWER SHARE until the 30 amp INCOMING AC BREAKER LED is ON. OPERATING TIP: If the breaker trips, reduce this setting. Setting the POWER SHARE feature to a lower setting may limit charger output, causing the batteries to require more time to become fully charged. POWER SHARE limits the amount of external AC current used by the charger. If the total AC load is larger than the AC power available, the external AC circuit breakers may trip. Select a lower POWER SHARE setting to reduce AC power consumption by the charger, thus reducing the total AC load. Available POWER SHARE settings vary by inverter/charger model. Only the settings that the inverter/charger supports are allowed. The following table shows the effective power share for a Freedom Inverter/Charger with a serial number less than 100,000.
Before you plug into an external AC source, note the breaker size. Press POWER SHARE until the appropriate INCOMING AC BREAKER LED is On. For example, to
POWER
SHARE
Specifications Model: 84-2056-01: 12 V Control Panel w/25' data cable Size: 5 3/4'' (L) X 3 3/4'' (W) X 1'' (D) Cutout Size: 4.7/8'' (W) X 2 7/8'' (H) Environmental: Splash resistant Operating temp: 070 °C Weight: 3 Oz. Power: Power for the Remote Control Panel is supplied
by the Freedom Inverter/Charger.
Export Model The export model has power share levels of 2.5, 7.5, 10, 15, and 25 amps. The following table shows the effective power share if a Freedom Inverter/Charger with a serial number less than 100,000 is used.
REMOTE POWER SHARE USED BY FREEDOM POWER MODEL: F10E (EXPORT) SHARE SN: 70746 20 NA 16 30 10 20 6 15 4 5
<