Instructions

Table Of Contents

ENGLISH DEUTSCH FRANCAIS ESPAÑOL POLSKI ITALIANO

OFFICE

SAFETY INFORMATION

All cable protectors in the DEFENDER

SERIES are designed to protect cables of all types against damage, and

visitors as well as operators from injuries by tripping. To ensure these goals, the following safety instructions for

use of the cable protectors must be observed:

• This user's manual is an integral part of the product and must be read carefully before use.

• DEFENDER

cable protectors may only be used in accordance with their intended purposes and maximum

load-bearing capacity. Valid parameters can be found in the detailed description of the respective product

variant.

• DEFENDER

cable protectors are designed for use on ﬁrm and level ground. The load speciﬁed in the detailed

descriptions is achieved only on level and solid ground. Load-bearing capacity may be greatly reduced on

uneven or soft ground.

• Please note that additional markings / hazard warnings or even permits may be required when using cable

protectors on public thoroughfares, walkways, etc.

• Use DEFENDER

cable protectors only with original replacement parts and accessories.

HAZARD

Incorrect insulation Life-threatening danger due to electric shock  Only use cables that comply

with the prescribed installation regulations with regard to voltage, current, insulation material, load

capacity, etc.

Caution! Tripping hazard.

ESPECIALLY IMPORTANT:

• Do not modify the product in ANY way. Modiﬁcations to the DEFENDER

cable protector

change the product’s characteristics, reduce its protective effect, and lead to a loss of the warranty.

• Do NOT bridge over ANY ditches, shafts, stairs, or similar depressions.

• Do NOT support pedestals, scaffolding, beams, and similar on the cable protectors.

• Do NOT run rigid gas lines in the cable protectors.

• Do NOT run cables with a voltage >500V in the cable protectors.

• Fill the cable ducts up to a max. of 70% to the underside of the cover.

To ensure that the trip protection does not itself become a tripping hazard:

• Connect the cable protectors in complete sections.

• Check that the connectors are ﬂush for each installation.

• Check that the lid closures function for each installation.

• Make sure that the lid closure snaps securely into the base.

• Keep the hinge area and lid closure clean.

• Remove any excess lubricant from the hinges after care.