User Manual

2524

GO SWISSDRIVE

 8. STOPWATCH

With the stopwatch function (1) of your Evo control unit you can stop the time taken

for a distance covered. Each measurement consists of a time measurement and the

distance covered which is indicated in kilometres or miles.

Start the stopwatch by pressing the Conrm key when the stopwatch menu is indi-

cated.

Pressing the Conrm key once again stops the measurement (2). Pressing the Con-

rm key long saves the measurement and resets the stopwatch. If you want to conti-

nue the measurement after a pause however, just press the Conrm key once again.

Keep in mind that only the two last measurements will be saved. By

saving a new measurement an older measurement is deleted.

The distance covered is only indicated correctly if the circumference

of tyre of your pedelec/e-bike is set correctly. You can adjust the cir-

cumference of tyre in the settings (see chapter “Congurations and

settings”).

 9. OVERVIEW TOTAL DATA

At standstill of your pedelec/e-bike further menus are enabled which provide useful

information and settings. The rst of these menus give you a compact overview of the

lifetime data of your pedelec/e-bike.

The menu is structured analogous to the tour menu. There you will nd information

- on the total distance covered (3a),

- on the total power consumption since the beginning of the tour (3b),

- on the mean speed (3c),

- on the maximum speed (3d) and

- on the total ride time (3e).

Unlike the tour data, the total data cannot be changed or cleared by you.

The total data are only indicated correctly if the circumference of tyre

of your pedelec/e-bike is set correctly. You can adjust the circumfe-

rence of tyre in the settings (see chapter “Congurations and set-

tings”).

 10. PHONE MENU

Your Evo control unit offers you the option to connect a mobile phone via Bluetooth

4.0. Instructions on how to connect a mobile phone are given in the chapter “Con-

gurations and settings”. Whether your mobile phone supports the Bluetooth 4.0 stan-

dard can be gathered from the operating manual of your mobile phone.

When your Evo control unit is connected with a mobile phone, incoming calls and

SMS are shown on the display. First, you will see a pop-up appearing shortly (see

chapter “Pop-ups and warnings”) (4).

1 32 4