User Manual

2928

GO SWISSDRIVE

The error indicator is completed with possible corrective measures in

concise form. In case the error cannot be remedied with these measu-

res, have the pedelec/e-bike checked by a dealer.

You can delete the list of errors occurred by navigating with the +/–keys of the hand-

lebar remote to the “Delete list“ button (1) and by pressing the Conrm key.

In addition, the service menu shows the time or the mileage for the next service at

your dealer under the error list.

The indication of the service interval depends on the manufacturer

of your pedelec/e-bike. If this function is disabled, no information is

shown in this area.

 13. CONFIGURATION AND SETTINGS

You can make various basic settings in the conguration menu (2) and, in addition,

adjust the Evo control unit to your particular needs and requirements.

In case there will arise any questions or problems during the congu-

ration of the Evo control unit described in the following, contact your

dealer.

The conguration menu is divided into six different submenus which you select

by navigating with the +/–keys of the handlebar remote to the desired button and by

pressing the Conrm key.

The currently marked button is highlighted green (3). From a submenu you can return

to the main menu by navigating to the “Conguration” button at the top of the subme-

nu – which is highlighted green – and by pressing the Conrm key of the handlebar

remote subsequently.

Within the submenu you can switch between the different buttons with the +/–keys

of the handlebar remote whereas the currently marked button is highlighted green.

If you can select between several options for one setting, the currently active option

is highlighted grey and checkmarked. To enable another option navigate with the

+/–keys to the desired option and press the Conrm key.

For numerical settings, such as e.g. the circumference of tyre, navigate with the +/–

keys of the handlebar remote to the desired button and press the Conrm key. Now

you can increase or reduce the value by pressing the +/–keys.

Pressing the +key increases the respective parameter by 1, pressing the –key redu-

ces the respective parameter by 1.

By pressing the +/–keys long you can enable the fast-forward which remains enabled

as long as you press the key. Once the desired value is reached, you can save it by

pressing the Conrm key.

A full description of the individual submenus is given in the following chapters.

13.1. System settings

In the submenu “System settings” (4) you can make various basic settings of your

system.

1 2