User Manual

3130
GO SWISSDRIVE
For the display of the distances and speeds you can select between the metric
system and the imperial system. In the metric system distances are displayed in
kilometres (km) and the speeds in kilometres per hour (km/h); in the imperial system
distances are displayed in miles (m) and speeds in miles per hour (mph).
Your Evo control unit offers various menu languages between which you can select.
The possible options depend on the conguration of the manufacturer of your pedelec/
e-bike. The languages German and English are available as standard.
With the parameter “Power off after min” (1) you can set after how many minutes
without input and movement of your pedelec/e-bike you want the system to switch
off to save energy.
I
Make sure the time set is not too short to avoid that the system swit-
ches off unintentionally, e.g. during a rather long stop in front of red
trafc lights. In case the system nevertheless switches off unintentio-
nally, you can enable it with the On/Off key of the handlebar remote or
with any other key at any time.
The Evo control unit has an integrated brightness sensor. This sensor adapts the
display’s backlighting automatically to the ambient brightness. You can increase or
reduce the basic brightness via the parameter “Brightness”. When the parameter is
set to 100% the automatic control is disabled and the backlighting is always at maxi-
mum regardless of the ambient brightness.
i
The automatic brightness sensor is not enabled in all variants of the
Evo display. In these variants you can set the display brightness ma-
nually in three steps.
With the parameter “Circumference of tyre” (2) you can enter the circumference
of tyre of your pedelec/e-bike into the system. The unit for the circumference of tyre
is millimetre (mm).
A
Keep in mind that the circumference of tyre is the basis for many cal-
culations, such as the indicated speed, the distance you have ridden
and the remaining range. If possible, have this setting done when you
collect your pedelec/e-bike from the dealer.
If you enable the option “Clear tour after 4h autom.” (3), the tour data are deleted
after each standstill longer than four hours. The next time the display is switched on
the tour data will be reset.
In this menu, you can furthermore clear the tour data manually with the button “Clear
tour” at any time.
13.2. Date and time
In the submenu “Date and time” (4) you can set the date and the current time.
Furthermore, you can select between a time indication in the 24-hour mode or in the
12-hour mode. In the 12-hour mode the indication AM (Ante Meridiem) or PM (Post
Meridiem) is displayed in addition on the right side of the time in the status bar.
13.3. Bluetooth
Your Evo control unit has an integrated Bluetooth chip and can be connected via Blu-
etooth 4.0 with various compatible devices, such as for ex. mobile phones. Whether
your mobile phone supports the Bluetooth 4.0 standard can be gathered from the
operating manual of your mobile phone.
To connect a compatible mobile phone you have to enable the Bluetooth interface of
this mobile phone rst. For more details in this regard see the operating manual of
your mobile phone.
1
4
2
3