User Manual

54
GO SWISSDRIVE
 1. INTRODUCTION
The Evo control unit is the communication interface with the GO SwissDrive system.
It offers you a huge number of functions and individualisation options. The following
chapter is a short overview with the description of the basic operation of the Evo con-
trol unit. You will nd a detailed description of all functions and conguration options
of the Evo control unit in the following chapters.
 2. SHORT OVERVIEW
2.1. Components of the Evo control unit
The Evo control unit consists of three components (1):
- display (1a),
- docking station (1b) and
- handlebar remote (1c)
The display is the display unit of your Evo control unit.
The system is controlled by the keys of the handlebar remote.
The docking station connects the display with the other components of the GO
SwissDrive system. In addition, the docking station has a USB port through which
data can be transferred and cell phones can be charged up to a current of 1.0 A.
2.2. Mounting the display on the docking station
Mount the display on the upper edge of the docking station (2). Subsequently slide
the display opposite to the direction of motion until it engages with an audible click in
the docking station (3).
To remove the display press down the lever on the upper edge of the docking station
and slide the display to the front until it can be removed (4).
I
If you want to mount the display permanently on the docking station,
it can be secured with a screw integrated into the docking station. To
mount and remove the display the screw has to be unscrewed nearly
fully by using a 3-mm Allen key. To secure the display with the screw,
mount the display rst and tighten the screw subsequently.
2.3. Operation of the Evo control unit
Your GO SwissDrive system is controlled by the handlebar remote, which can be
mounted on the right or left side of the handlebars close to the grips.
1
a
b
c
4
2
3