Installation manual

18600 and CTP-NB Series Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
2
Receiving & Inspecting Equipment ...................................................... 2
Specifications ........................................................................................ 3
Refrigerant Charges .............................................................................. 4
Installation ............................................................................................ 4
Operation
18600PTBM & PTL Series ................................................................ 5
18600BUCM & BSTM Series ............................................................ 5
18600PDL Series ............................................................................... 6
CTP-NB Series ................................................................................... 6
Pressure Control Settings ..................................................................... 7
Temperature Control Settings ............................................................... 7
Care And Cleaning ..............................................................................8-9
Wiring Diagram
18600PTBM & PTL Series .............................................................. 10
18600BUCM & BSTM Series .......................................................... 11
18600PDL ........................................................................................ 11
CTP-NB Series ................................................................................. 12
Replacement Parts ......................................................................... 13-22
Standard Labor Guidelines.................................................................. 23
Standard Warranties ......................................................................24-26
Notes ................................................................................................... 27
The serial number on 18600 Series units is located on the electrical
specifications tag affixed inside the compressor section next to the
pressure control.
The serial number on CTP-NB Series units is located on the front of
the unit.
Always have the serial number of your unit available when calling for
parts or service.
Warranty may be deemed invalid if other than
authorized OEM (original equipment manufacture)
replacement parts are used in Delfield equipment.
©2011 The Delfield Company. All rights reserved. Reproduction without
written permission is prohibited. “Delfield” is a registered trademark of The
Delfield Company.
Contents
Serial Number Information
Receiving And Inspecting The Equipment
Even though most equipment is shipped crated, care should be
taken during unloading so the equipment is not damaged while
being moved into the building.
1. Visually inspect the exterior of the package and skid or
container. Any damage should be noted and reported to
the delivering carrier immediately.
2. If damaged, open and inspect the contents with the
carrier.
3. In the event that the exterior is not damaged, yet upon
opening, there is concealed damage to the equipment
notify the carrier. Notification should be made verbally as
well as in written form.
4. Request an inspection by the shipping company of the
damaged equipment. This should be done within 10 days
from receipt of the equipment.
5. Check the lower portion of the unit to be sure legs or
casters are not bent.
6. Also open the compressor compartment housing and
visually inspect the refrigeration package. Be sure lines
are secure and base is still intact.
7. Freight carriers can supply the necessary damage forms
upon request.
8. Retain all crating material until an inspection has been
made or waived.
Uncrating the Equipment
First cut and remove the banding from around the crate.
Remove the front of the crate material, use of some tools will
be required. If the unit is on legs remove the top of the crate
and lift the unit off the skid. If the unit is on casters it can be
"rolled" off the skid.