User manual

140 Understanding the Printer Menus
Reset Wireless
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network
settings are reset to their default values.
NOTE: This item is available only when the Ethernet cable is disconnected and Wi-Fi is set to On .
TCP/IP
Purpose:
To configure TCP/IP settings. The change takes effect after the printer is turned off and then on.
Va lu e s:
Connection
Status
No Entry Indicates that no device is available.
HOST xxxxxx Displays the connected device name and current status of the
Wi-Fi Direct network.
Disconnect Disconnect the device.
Reset Passphrase Disconnect the device and reset passphrase.
Current Role Client Displays the current group role of the
printer
Current SSID Displays the current SSID. Confirm it when you select the
Wi-Fi Direct network on your mobile device.
SSID Specifies a name to identify the wireless network.
PassPhrase Print Passphrase Prints the passphrase. Confirm it when you enter the
passphrase to your mobile device.
Reset Passphrase Cancel
Start
WPS Method Push Button Configuration* Configures the Wi-Fi Direct network with WPS-PBC.
PIN Code Configures the Wi-Fi Direct network with PIN code assigned
automatically by the printer.
No* Does not reset the wireless setting.
Yes Resets the wireless setting.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv4 Ethernet/
IPv4 Wireless*
1
Get IP Address AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Manually sets the IP address on the operator panel.
IP Address Manually sets the IP address allocated to the printer.
Subnet Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.