User manual

Dell™ Printer Configuration Web Tool 91
Va l ue s :
Fax Settings
Purpose:
To configure the basic fax settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Va l ue s :
Resolution Standard* Suitable for documents with normal sized characters.
Fine Suitable for documents containing small characters or thin lines or documents
printed using a dot-matrix printer.
Super Fine Suitable for documents containing extremely fine detail. The super fine mode is
enabled only if the remote machine also supports the super fine resolution.
Ultra Fine Suitable for documents containing photographic images.
Lighter/Darker Sets the default density level to be used for fax transmission.
Delayed Start Sets the fax transmission start time when sending a fax at a specified time.
Receive Mode Telephone Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, and then pressing the remote receive code.
Fax* Automatically receives faxes.
Telephone /Fax When the printer receives an incoming fax, the external telephone rings for the
time specified in Auto Receive Tel/Fax, and then the printer automatically
receives a fax. If an incoming call is not a fax, the printer beeps from the internal
speaker indicating that the call is a telephone call.
Answer
Machine/
Fax
The printer can share a telephone line with an answering machine. In this mode,
the printer will monitor the fax signal and pick up the line if there are fax tones.
If the phone communication is using serial transmission in your country (such as
Germany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland),
this mode is not supported.
DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the telephone
company. After the telephone company has provided a separate number for
faxing with a distinctive ring pattern, configure the fax setup to monitor for that
specific ring pattern.
Auto Receive Fax Sets the interval at which the printer goes into the fax receive mode after receiving an incoming
call.
Auto Receive Tel/Fax Sets the interval at which the printer goes into the fax receive mode after the external telephone
receives an incoming call.
Auto Receive Answer/Fax Sets the interval at which the printer goes into the fax receive mode after the external answering
machine receives an incoming call.
Line Monitor Sets the volume of the line monitor, which audibly monitors a transmission through the internal
speaker until a connection is made.
Ring Tone Volume Sets the volume of the ring tone, which indicates that an incoming call is a telephone call through
the internal speaker when Receive Mode is set to Tel ephone/Fax.
Line Type Sets the line type.
Tone/Pulse Sets the dialing type.
Resend Delay Specifies the interval between transmission attempts.