User Manual
Table Of Contents
- Dell EMC PowerEdge R350 Technical Guide
- Contents
- System overview
- System features and generational comparison
- Chassis views and features
- Processor
- Memory subsystem
- Storage
- Networking
- Expansion cards and expansion card risers
- Power, thermal, and acoustics
- Rack, rails, and cable management
- Supported operating systems
- Dell EMC OpenManage systems management
- Dell Technologies Services
- Dell EMC ProDeploy Enterprise Suite
- Dell EMC Data Migration Service
- Dell EMC ProSupport Enterprise Suite
- Dell EMC ProSupport Plus for Enterprise
- Dell EMC ProSupport for Enterprise
- Dell EMC ProSupport One for Data Center
- ProSupport for HPC
- Support Technologies
- Services for Data Security
- Dell Technologies Education Services
- Dell Technologies Consulting Services
- Dell EMC Managed Services
- Appendix A. Additional specifications
- Appendix B. Standards compliance
- Appendix C Additional resources
Figure 20. Sliding rails
Installing 15G Systems in Sliding Rails
To install the 15G system in sliding rails:
1. Pull the inner slide rails out of the rack until they lock into place.
● Hold the system by its front and back ends and tilt the front end upward slightly.
● Check the window on the sides of both rails to confirm that the heads of the standoffs are visible before adjusting or
releasing your grip on the back end of the system.
● Use your free hand to hold the rail against the side of the chassis if needed as the system is rotated downward into the
remaining J-slots.
2. Locate the rear rail standoff on each side of the system and lower them into the rear J-slots of the slide assembly.
3. Rotate the system downward until all the rail standoffs are seated in the J-slots.
4. Push the system inward until the lock levers click into place. Press the slide-release lock buttons on both rails and slide the
system into the rack.
Figure 21. Sliding rails installation
Rack, rails, and cable management
35