User's Manual

Bonjour (mDNS)
Purpose:
To configure the detailed settings for Bonjour.
Values:
Host
Name
Specifies the host name up to 63 alphanumeric characters and "-" (dash). The original setting will remain
valid if no input is made.
Printer
Name
Specifies the printer name up to 63 alphanumeric characters and symbol sets. The original setting will
remain valid if no input is made.
SNMP
Purpose:
To configure the detailed settings of SNMP.
Values:
Enable SNMP v1/v2c
Protocol
Select the check box to enable the SNMP v1/v2c protocol.
Edit SNMP v1/v2c
Properties
Click to display SNMP v1/v2c page and to edit the setting of SNMP v1/v2c protocol
from the page.
Enable SNMP v3 Protocol Select the check box to enable the SNMP v3 protocol.
Edit SNMP v3 Properties
Click to display SNMP v3 page and to edit the setting of SNMP v3 protocol from the
page.
Without SSL communication is enabled, you cannot click this item.
SNMP v1/v2c
Purpose:
To edit the detailed settings of SNMP v1/v2c protocol.
To enter this page, click Edit SNMP v1/v2c Properties in the SNMP page.
Values:
Community
Name (Read
only)*
1
Specifies the community name to access (read only) data using up to 31 alphanumeric characters.
The original setting will remain valid if no input is made. Characters entered for community name in
the previous settings will not be displayed on the screen. The default Read Community is public.
Re-enter
Community
Name (Read
only)*
1
Enter the community name to access (read only) data again to confirm it.
Community
Name
(Read/Write)*
1
Specifies the community name to access (read and write) data using up to 31 alphanumeric
characters.
The original setting will remain valid if no input is made. Characters entered for community name in
the previous settings will not be displayed on the screen. The default Read/Write Community is
private.
Re-enter
Community
Name
(Read/Write)*
1
Enter the community name to access (read and write) data again to confirm it.
Community
Name (Trap)*
1
Specifies the community name used for trap up to 31 alphanumeric characters.
The original settings will remain valid if no input is made. Characters entered for Community Name
(Trap) in the previous settings will not be displayed on the screen. The default Trap Community is " "
(NULL).