User's Manual

Re-enter
Community
Name (Trap)*
1
Enter the community name used for trap again to confirm it.
Trap
Notification 1-4
Select the check boxes to notify trap occurrence. In this case, specify the IP address and IP socket in
the following format:
IPv4
Specify the IP address and IP socket in the nnn.nnn.nnn.nnn:mmmmm format. Each section of "nnn"
is a variable value between 0 and 255. Note that values 127 and 224-254 are not valid for the first
three-digits only. IP socket mmmmm is a variable value between 0 and 65,535.
IPv6
Specify the IP address and IP socket in the xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:mmmmm
format. Each section of "xxxx" is a hexadecimal variable value between 0 and ffff. IP socket
mmmmm is a variable value between 0 and 65,535.
Authenticate
Error Trap
Select the check box to notify Authenticate Error Trap.
*
1
The default value of each items can be changed by using Dell Printer Configuration Web Tool.
SNMP v3
Purpose:
To edit the detailed settings of SNMP v3 protocol.
To enter this page, click Enable SNMP v3 Protocol in the SNMP page.
Values:
Administrator Account
Account Enabled Select the check box to enable the administrator account.
User Name Enter the user name of the administrator account.
Authentication
Password
Specifies the authentication password of the administrator account
using 8 to 32 alphanumeric characters.
Re-enter
Authentication
Password
Enter the authentication password of the administrator account
again to confirm it.
Privacy Password
Specifies the privacy password of the administrator account using 8
to 32 alphanumeric characters.
Re-enter Privacy
Password
Enter the privacy password of the administrator account again to
confirm it.
Print Drivers / Remote
Client Account
Account Enabled
Select the check box to enable the print drivers and remote client
account.
Reset to default
Password
Click to reset the password for the print drivers and remote client
account to default.
Wireless LAN
Purpose:
To configure the detailed setting for the wireless network.
To use the wireless adapter, be sure to disconnect the network cable.
NOTE: Once wireless LAN is activated, wired LAN protocol will be disabled.
Values:
SSID Specifies the name that identifies the wireless network. Up to 32 alphanumeric characters.