User's Manual

Certificate
Details*
3
Category
Displays the device to certificate selected at Certificate Management page
or SSL/TLS page.
Issued To Displays the device to certificate.
Issuer Displays the issuer to certificate.
Serial Number Displays the serial number of the device.
Size of Public
Key
Display Size of Public Key.
Valid From Displays the time the certificate is valid.
Valid Until Displays the time the certificate is invalid.
Status Displays whether certificate is valid or not.
Certificate
Purpose
Displays the purpose of certificate.
Certificate
Selection
Status
Displays the type of device certificate you selected.
E-mail Address Displayed only when an e-mail address is specified in the certificate.
Use This
Certificate*
2
Click to apply this certificate to the device.
Delete Click to delete this certificate.
Export This
Certificate*
2
Click to export the certificate to the other device.
*
1
This item is available only when the self-signed certificate has been generated.
*
2
This item is displayed only when the optional hard disk is installed and is set to On for encryption.
*
3
This item is effective only when connected via SSL/TLS (https). Only the administrator is allowed to display the
pages.
*
4
This item is displayed only when the optional hard disk is installed and is set to On for encryption. If not, "Certificate
Details" is displayed.
IPsec
Purpose:
To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the printer.
Values:
Protocol Select the check box to enable the protocol.
IKE
Select IKE authentication. Digital Signature is displayed on the list only when an effective digital
signature is set up.
Pre-Shared Key*
1
Specifies a shared key when Pre-Shared Key is selected for the IKE setting. Up to 255
alphanumeric characters, periods, and hyphens can be used.
Re-enter Pre-Shared
Key
Enter the shared key again to confirm it.
Device Certificate*
1
Displays the device certificate.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800 minutes.
IPsec SA Lifetime Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
DH Group Selects the DH group.
PFS Selects the check box to enable the PFS setting.
Remote peers IPv4
address
Specifies the IP address to connect to.