User's Manual

Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and then on again.
Values:
LPD
Enable* Enables the LPD port.
Disable Disables the LPD port.
Port9100
Enable* Enables the Port9100 port.
Disable Disables the Port9100 port.
IPP
Enable* Enables the IPP port.
Disable Disables the IPP port.
FTP
Enable* Enables FTP.
Disable Disables FTP.
NetWare
Enable* Uses IP for NetWare.
Disable Does not use IP for NetWare.
WSD
Enable* Enables the WSD port.
Disable Disables the WSD port.
SNMP
Enable* Enables the UDP.
Disable Disables the UDP.
E-Mail Alert
Enable* Enables the E-mail Alerts feature.
Disable Disables the E-mail Alerts feature.
EWS
Enable* Enables an access to Dell Printer Configuration Web Tool embedded in the printer.
Disable Disables an access to Dell Printer Configuration Web Tool embedded in the printer.
Bonjour(mDNS)
Enable* Enables the Bonjour(mDNS).
Disable Disables the Bonjour(mDNS).
Telnet
Enable* Enables the Telnet.
Disable Disables the Telnet.
HTTP-SSL/TLS*
1
Enable* Enables the HTTP-SSL/TLS.
Disable Disables the HTTP-SSL/TLS.
*
1
This item is displayed only when the self-signed certificate is generated.
IP Filter
Purpose:
To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP
addresses. The change becomes effective after the printer is turned off and then on again.
Values:
No. n/Address
(n is 1-5.)*
1
Sets the IP address for Filter n.
No. n/Mask
(n is 1-5.)*
1
Sets the address mask for Filter n.
No. n/Mode (n is 1-5.)*
1
Off* Disable the IP Filter feature for Filter n.
Accept Accepts an access from the specified IP address.