User's Manual

When Using the Operator Panel
You can specify only the settings of ColorTrack Mode, No Account User Print, and ColorTrack Error Report using
the operator Panel.
1. Press Menu button.
2. Press
button until Admin Menu is highlighted, and then press (Set) button.
3. Press
button until System Settings is highlighted, and then press (Set) button.
4. Press
button until ColorTrack Mode is highlighted, and then press (Set) button.
5. Press
button until External Mode is highlighted, and then press (Set) button.
6. Press Cancel or
button to return to the previous menu.
7. Press
button until No Account User Print is highlighted, and then press (Set) button.
8. Press
button to select Off or On, and then press (Set) button.
9. Press Cancel or
button to return to the previous menu.
10. Press
button until ColorTrack Error Report is highlighted, and then press (Set) button.
11. Press
button to select Off or On, and then press (Set) button.
12. Turn off the printer to apply the settings.
ColorTrack Mode
The following two authentication modes are available: the Internal Mode using user information registered on the printer,
and the External Mode using user information registered on an external server. To authenticate on the external
authentication server with External Mode, you need not register user information on the printer. The change becomes
effective after the printer is turned off and then on again.
No Account User Print
Specify whether to permit the printing of data with no authentication information. This setting is enabled when the printer
is restarted. The change becomes effective after the printer is turned off and then on again.
No-account User Password
Specify the password to be used for non-account user using 1 to 127 alphanumeric characters. If the password is left
blank (NULL), you cannot log in to a server. The change becomes effective after the printer is turned off and then on
again.
NOTE: When External Mode is specified and No Account User Print is set to On, you must set a password.
NOTE: When using an LDAP server, you also must set the same password on the server.
Re-enter No-account User Password
Enter the No-account user password again to confirm it.
ColorTrack Error Report