User guide

Dell PowerConnect 55xx Systems User Guide 103
Configuring MAC-Based ACEs Using CLI Commands
The following table summarizes the CLI commands for configuring
MAC-
based ACEs
.
The following is an example of some of the CLI commands:
Table 8-3. MAC Based ACE CLI Commands
CLI Command Description
permit {any|source-ip-address
source-wildcard}
{any|destination destination-
wildcard} [eth-type
0|aarp|amber|dec-
spanning|decnet-
iv|diagnostic|dsm|etype-6000]
[vlan vlan-id] [cos cos cos-
wildcard] [time-range time-
range-name]
Sets permit conditions for an MAC
access list (in MAC ACL configuration
mode).
deny {any|source source-
wildcard} {any|destination
destination-wildcard} [eth-type
0|aarp|amber|dec-
spanning|decnet-iv | diagnostic
|dsm|etype-6000] [vlan vlan-id]
[cos cos cos-
wildcard] [time-
range time-range-name][disable-
port|log-input]
Sets deny conditions for an MAC
access list.
console(config)# mac access-list extended server1
console(config-mac-al)# permit 00:00:00:00:00:01
00:00:00:00:00:ff any