User guide

Dell PowerConnect 55xx Systems User Guide 303
– Next Server — Enter the IP address of the next server in the boot
process of a DHCP client. If the next server in the boot process is not
configured, the DHCP server uses inbound interface helper addresses
as boot servers.
–
Next Server Name — Enter the name of the next server in the boot
process.
–
Image File Name — Enter the name of the file that is used as a boot
image.
Defining Static Hosts Using CLI Commands
The following table summarizes the CLI commands for defining static hosts.
See Table 11-53 for the remaining CLI commands that are common to the
Network Pool pages, but are used in the context DHCP Pool Host context.
Table 9-55. Defining Static Hosts Using CLI Commands
CLI Command Description
ip dhcp pool host
no ip dhcp pool host
Configures a DHCP static address
on a DHCP Server and enters the
DHCP Pool Host Configuration
mode.
Use the no form of this command to
remove the address pool.
ip host name address [address2
address3 address4]
no ip host name
Defines the static host name-to-
address mapping in the host cache.
Use the no form of this command to
remove the static hostname-to-
address mapping.
show hosts Displays the default domain name,
the list of name server hosts, the
static and the cached list of host
names and addresses.
clear host Deletes entries from the host name-
to-address cache.