User Manual

32 Troubleshooting
• Message : MPT firmware fault
Description : The adapter did not initialize properly. There may be a
problem with the adapter configuration. Reload the BIOS configuration.
Start the
Configuration Utility again and see if the issue persists.
•
Message : Updating Adapter List!
Description : A new adapter for which there is no record is found. A record
is created for it.
•
Message : Adapter(s) disabled by user
Description : An adapter is found, but it is disabled in the Configuration
Utility
and will not be used by the BIOS.
•
Message : Adapter configuration may have changed,
reconfiguration is suggested!
Description : A controller is moved or reinstalled in the system. Add it to
the boot order using the available resources.
•
Message : Memory allocation failed
Description : The controller cannot allocate enough memory to load the
Configuration Utility , its strings file, or its options file. Reboot the system.
•
Message : Invalid or corrupt image
Description : One of the images for the Configuration Utility , its strings
file, or its options file is corrupt. Reload the BIOS. Reflash the firmware.
•
Message : Image upload failed
Description : Cannot upload the image for the Configuration Utility , its
strings file, or its options file. Reload the BIOS. Reflash the firmware.
•
Message : Unable to load the Dell 6 Gbp SAS HBA
Configuration Utility
Description : Cannot load the Configuration Utility . This error usually
follows one of the four previous messages.
•
Message : Dell 6 Gbp SAS HBA configuration utility
will load after initialization!
Description : <Ctrl><C> is used to start the configuration utility but
insufficient memory is available. The
Configuration Utility loads (boots)
after POST initialization.