Installation and Service Manual

NOTE: Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
Figure 44. Removing the processor
Next steps
Replace the processor.
Installing the processor
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat
sink is necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the processor.
Steps
1. Align the pin 1 indicator of the processor with the triangle on the socket and place the processor on the socket.
CAUTION:
Positioning the processor incorrectly can permanently damage the system board or the processor.
Be careful not to bend the pins in the socket.
2. Lower the socket lever and push it under the tab to lock it.
NOTE:
If the processor has previously been used in a system, remove any remaining thermal grease from the processor
by using a lint-free cloth.
Figure 45. Installing the processor
52
Installing and removing system components