Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R250 Installation and Service Manual
- Contents
- About this document
- PowerEdge R250 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Optional optical drive
- Air shroud
- Cooling fans
- Intrusion switch
- Drive backplane
- Drives
- Cable routing
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional IDSDM module
- MicroSD card
- Optional BOSS S1 card
- PERC
- System battery
- Optional internal USB card
- Power supply unit
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
4. Remove the IDSDM module.
Steps
1. Locate the Micro-SD card slot on the IDSDM module, and press the card to partially release it from the slot. For more
information about the slot location, see System board jumpers and connectors section.
2. Hold the Micro-SD card and remove it from the slot.
NOTE: Temporarily label each Micro-SD card with its corresponding slot number after removal.
Figure 59. Removing the Micro-SD card
Next steps
Replace the MicroSD cards.
Installing the Micro-SD card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE: To use a Micro-SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: Ensure that you install the Micro-SD cards into the same slots based on the labels you had marked on the cards
during removal.
Steps
1. Locate the Micro-SD card slot on the IDSDM module. Orient the Micro-SD card appropriately and insert the contact-pin end
of the card into the slot. To locate IDSDM, see the System board jumpers and connectors section.
NOTE: The slot is keyed to ensure correct insertion of the card.
2. Press the card into the slot to lock it into place.
Installing and removing system components
63