Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R250 Installation and Service Manual
- Contents
- About this document
- PowerEdge R250 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Optional optical drive
- Air shroud
- Cooling fans
- Intrusion switch
- Drive backplane
- Drives
- Cable routing
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional IDSDM module
- MicroSD card
- Optional BOSS S1 card
- PERC
- System battery
- Optional internal USB card
- Power supply unit
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 1. Features available on the front of the system
Item Ports, panels, and
slots
Icon Description
1 Left control panel with
iDRAC reset button
Contains the system health, and system ID.
NOTE: To reset the iDRAC without changing any saved
settings press and hold the System Identification button for
at least 16 seconds.
2 Optical drive N/A One optional slim SATA DVD-ROM drive or DVD+/-RW drive.
3 Drive N/A Enables you to install drives that are supported on your system.
4 Right control panel N/A Contains the power button, USB port, iDRAC Direct micro port,
and the iDRAC Direct status LED.
5 Information tag N/A The Information tag is a slide-out label panel that contains
system information such as Service Tag, NIC, MAC address,
and so on. If you have opted for the secure default access
to iDRAC, the Information tag also contains the iDRAC secure
default password.
NOTE: For more information, see the Dell EMC PowerEdge R250 Technical Specifications on the product documentation
page.
Rear view of the system
Figure 4. Rear view of the system
Table 2. Rear view of the system
Item Ports, panels, or slots Icon Description
1 Serial port N/a Enables you to connect serail devices to the system.
2 Ethernet ports The Ethernet ports that are integrated on the system board
provide network connectivity. These NIC ports can also be shared
with iDRAC when iDRAC network settings is set to shared mode.
3 PCIe expansion card slot 1 N/a Enables you to connect PCI Express expansion cards.
4 PCIe expansion card slot
2
N/a Enables you to connect PCI Express expansion cards.
5 Cabled power supply unit Indicates the PSU.
8 PowerEdge R250 system overview