Manual

Back to Contents Page
 Internal Module With Bluetooth Wireless Technology
AdamoXPS™ServiceManual
Removing the Bluetooth Card
Replacing the Bluetooth Card



Removing the Bluetooth Card

1. Follow the instructions in Before You Begin.

2. Remove the computer battery (see Removing the Computer Battery).

3. Open the display (see Opening the Display).

4. Remove the palm rest assembly (see Removing the Palm Rest Assembly).

5. RemovethescrewthatsecurestheBluetooth™cardtotherightdaughterboard.

6. Lift the Bluetooth card to disconnect it from the connector on the right daughter board.

7. Turn the Bluetooth card over.

8. Disconnect the blue antenna cable from the Bluetooth card.
Replacing the Bluetooth Card

1. Follow the instructions in Before You Begin.

2. Connect the blue antenna cable to the Bluetooth card.

3. Turn the Bluetooth card over.

4. Align the connector on the Bluetooth card with the connector on the right daughter board, and press gently to connect the Bluetooth card to the right
daughter board.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Computer Battery) before working inside
the computer.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
1
screw
2
Bluetooth card