Manual


10. Slide and lift the computer base away from the display assembly.
Replacing the Display Assembly

1. Follow the instructions in Before You Begin.

2. Place the computer base in position and replace the two screws that secure the display assembly to the computer base.

3. Route the antenna cables and tape them in place if required.

4. Connect the following cables to their corresponding connectors on the system board:
l display cable
l left I/O board cable
l battery power cable
l AC adapter power cable
l right I/O board cable

5. ReplacetheBluetooth™card(seeReplacing the Bluetooth Card).

6. Replace the WLAN card (see Replacing the WLAN Card).

7. Replace the palm rest assembly (see Replacing the Palm Rest Assembly).

8. Replace the computer battery (see Replacing the Computer Battery).

Back to Contents Page

1
screws (2)
NOTE: Remove the service tag panel if you are replacing the display assembly (see Removing the Service Tag Panel).
NOTE: Replace the service tag panel if you are replacing the display assembly (see Replacing the Service Tag Panel).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.