Manual

Back to Contents Page
 Memory Module
AdamoXPS™ServiceManual
Removing the Memory Module
Replacing the Memory Module



Removing the Memory Module

1. Follow the instructions in Before You Begin.

2. Remove the computer battery (see Removing the Computer Battery).

3. Open the display (see Opening the Display).

4. Remove the palm rest assembly (see Removing the Palm Rest Assembly).


5. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up.

6. Remove the memory module from the memory module connector.
Replacing the Memory Module

1. Follow the instructions in Before You Begin.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Computer Battery) before working inside
the computer.
NOTE: The memory on your computer cannot be upgraded.
CAUTION: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
1
memory module
2
securing clips (2)
3
memory module connector
NOTE: The memory on your computer cannot be upgraded.