Manual


7. Disconnect the function key cable from the connector on the system board.

8. Lift the connector latch that secures the touch pad cable to the touch pad connector and remove the cable.


9. Lift the palm rest assembly off the computer base.
Replacing the Palm Rest Assembly

1. Follow the instructions in Before You Begin.

2. Slide the touch pad cable into the connector on the touch pad. Press down on the connector latch to secure the touch pad cable to connector on the
touch pad.

3. Connect the function key cable to the connector on the system board.


4. Align the palm rest assembly with the computer base and gently snap the palm rest assembly into place.

5. Close the display and turn the computer over.

6. Replace the eighteen screws that secure the base cover to the computer.

7. Replace the computer battery (see Replacing the Computer Battery).
Back to Contents Page

1
palm rest assembly
2
touch pad cable
3
function key cable
CAUTION: To prevent damage to the display hinges, ensure that you do not adjust the angle between the display and the computer base after
removing the palm rest assembly.
CAUTION: You must route these cables properly to prevent them from being pinched or crimped at the hinges.
NOTE: The screws that secure the base cover are of different sizes. Ensure that you replace the correct screws to the base cover.