Service Manual

Steps

1. Connect the battery cable to the system board.

2. Slide the notches on the top of the base cover under the rear I/O-cover and snap the base cover into place on the palm-rest

assembly.

3. Tighten the six captive screws on the base cover.

4. Replace the two screws (M2.5x5) that secure the base cover to the palm-rest assembly.

Next steps

1. Follow the procedure in

After working inside your computer.

M.2 solid-state drive

Removing the M.2 2230 solid-state drive

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.