Service Manual

2. Remove the base cover.

About this task

The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.

Steps

1. Disconnect the coin-cell battery cable from the connector on the system board.

2. Peel and lift the coin-cell battery off the right I/O-board along with its cable.

3. Disconnect the coin-cell battery from the coin-cell battery cable.

Installing the coin-cell battery

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the coin-cell battery and provides a visual representation of the installation procedure.