Service Manual

Steps

1. Using the alignment posts, place the left speaker on the palm-rest assembly.

NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.

2. Route the speaker cable through the routing guides on the palm-rest assembly.

3. Using the alignment posts, place the right speaker on the palm-rest assembly.

NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.

4. Connect the speaker cable to the right I/O-board.

Next steps

1. Install the

base cover.

2. Follow the procedure in After working inside your computer.

Rear-I/O cover

Removing the rear I/O-cover

Prerequisites

1. Follow the procedure in

Before working inside your computer.

2. Remove the base cover.

About this task

The following image indicates the location of the rear I/O-cover and provides a visual representation of the removal procedure.