Service Manual

Installing the power-button assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power-button assembly and provides a visual representation of the installation

procedure.

Steps

1. Place the power-button assembly and its cable in the slot on the palm-rest assembly.

2. Place the power-button bracket on the power-button assembly.

3. Connect the power-button assembly cable to the left I/O-board and close the connector latch.

4. Replace the three (M2x1.9) screws that secure the power-button bracket to the palm-rest assembly.

5. Adhere the power-button assembly cable on the palm-rest assembly.

Next steps

1. Install the

system board.

2. Install the battery.

3. Install the rear I/O-cover.

4. Install the 2230 solid-state drive. (if applicable)

5. Install the 2280 solid-state drive. (if applicable)

6. Install the base cover.

7. Follow the procedure in After working inside your computer.