User's Manual

Installing the driver locally

A locally connected machine is a machine directly attached to your computer If the installation window does not appear, click Start > All programs >

using the cable. If your machine is attached to a network, skip the following

Accessories > Run.

steps below and go on to installing a network connected machine’s driver (see

X:\Setup.exe replacing “X” with the letter, which represents your CD/

"Installing driver over the network" on page 141).

DVD drive and click OK.

• For Windows 8,

• If you are a Mac or Linux operating systems user, refer to the "Installation

If the installation window does not appear, from Charms, select

for Mac" on page 131 or "Installation for Linux" on page 133.

Search > Apps and search for Run. Type in X:\Setup.exe, replacing

• The installation window in this User’s Guide may differ depending on the

“X” with the letter that represents your CD/DVD drive and click OK.

machine and interface in use.

If “Tap to choose what happens with this disc.” pop-up window

• Only use a USB cable no longer than 3 meters (118 inches).

appears, click the window and select Run Setup.exe.

Select New Printer.

Windows

Make sure that the machine is connected to your computer and

powered on.

If the “Found New Hardware Wizard” appears during the installation

procedure, click Cancel to close the window.

Insert the supplied software CD into your CD/DVD drive.

The software CD should automatically run and an installation window

will appear.

1. Introduction