Users Guide
Table Of Contents
- Revision History
- Table of Contents
- Regulatory and Safety Approvals
- Functional Description
- Network Link and Activity Indication
- Features
- Software and Hardware Features
- Virtualization Features
- VXLAN
- NVGRE/GRE/IP-in-IP/Geneve
- Stateless Offloads
- UDP Fragmentation Offload
- Stateless Transport Tunnel Offload
- Multiqueue Support for OS
- SR-IOV Configuration Support Matrix
- SR-IOV
- Network Partitioning (NPAR)
- RDMA over Converged Ethernet – RoCE
- Supported Combinations
- Installing the Hardware
- Software Packages and Installation
- Windows Driver Advanced Properties and Event Log Messages
- Teaming
- System-level Configuration
- ISCSI Boot
- VXLAN: Configuration and Use Case Examples
- SR-IOV: Configuration and Use Case Examples
- NPAR – Configuration and Use Case Example
- RoCE – Configuration and Use Case Examples
- DCBX – Data Center Bridging
Windows Driver Advanced Properties and Event Log MessagesNetXtreme-E User’s Manual
September 4, 2019 • NetXtreme-E-UG103 Page 40
Event Log Messages
Tabl e 2 5 provides the Event Log messages logged by the Windows NDIS driver to the Event Logs.
SR-IOV Enable or Disable. Default Enabled. This parameter
works in conjunction with HW
configured SR-IOV and BIOS
configured SR-IOV setting.
TCP/UDP checksum offload IPV4 TX/RX enabled, TX enabled or RX
Enabled or offload disabled.
Default RX and TX enabled.
TCP/UDP checksum offload IPV6 TX/RX enabled, TX enabled or RX
Enabled or offload disabled.
Default RX and TX enabled.
Transmit Buffers (0=Auto) Increment of 50. Default Auto.
Virtual Machine Queue Enable or Disable. Default Enabled.
VLAN ID User configurable number. Default 0.
Table 25: Windows Event Log Messages
Message ID Comment
0x0001 Failed Memory allocation.
0x0002 Link Down Detected.
0x0003 Link up detected.
0x0009 Link 1000 Full.
0x000A Link 2500 Full.
0x000b Initialization successful.
0x000c Miniport Reset.
0x000d Failed Initialization.
0x000E Link 10Gb successful.
0x000F Failed Driver Layer Binding.
0x0011 Failed to set Attributes.
0x0012 Failed scatter gather DMA.
0x0013 Failed default Queue initialization.
0x0014 Incompatible firmware version.
0x0015 Single interrupt.
Table 26: Event Log Messages
0x0016 Firmware failed to respond within allocated time.
0x0017 Firmware returned failure status.
0x0018 Firmware is in unknown state.
0x0019 Optics Module is not supported.
Table 24: Windows Driver Advanced Properties (Cont.)
Driver Key Parameters Description