Users Guide
Table Of Contents
- About This Document
- Introduction
- General Troubleshooting
- Connectivity
- Configuration
- Firmware Download Errors
- Security
- Virtual Fabrics
- ISL Trunking
- Zoning
- Diagnostic Features
- Switch Type and Blade ID
- Hexadecimal Conversion
- Index
Fabric OS Troubleshooting and Diagnostics Guide 43
53-1002930-01
Port mirroring
3
Configuring a port to be a mirror port
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the portCfg mirrorport [slot number/] port number
--enable command.
NOTE
The enable command enables the port as a mirror port. The disable command disables the mirror
port configuration.
Adding a port mirror connection
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the portMirror
--add slotnumber/portnumber SourceID DestID command.
The configuration database keeps information about the number of port mirror connections
configured on a switch, the number of chunks of port mirroring data that are stored, and the chunk
number.
Deleting a port mirror connection
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the portMirror
--del SourceID DestID command.
For example, to delete the port mirror connection on mirror port 2, you could enter the
following command:
switch:admin> portMirror --del 0x011400 0x240400
When removing a mirror connection, always use this method to ensure that the data is cleared.
Deleting a connection removes the information from the database.
FS8-18 3
FX8-24 3
TABLE 9 Maximum number of mirror connections (Continued)
Model Maximum number of mirror connections (chassis-wide)