Quick Reference Guide

setarraycfg
Description This command is applicable only for CMC. Use this command to configure storage
array properties.
Synopsis
racadm setarraycfg -m module –n <member_name> <member_ip>
<member_mask> <member_gateway> -e 0|1 -g <groupname>
<group_id> <group_password> [<admin_password>] [-f A|B]
racadm setarraycfg -f A|B
NOTE:
The valid value for -m is server-n, where n = 1 to 16.
Input
• -m — Module is one of the following values:
– server-n: where n = 1 to 7 and 9 to 15
• <member_name> — A unique and descriptive name that is fewer than 64
alphanumeric characters, without spaces, and the first character is a letter or
a number. It is used only to identify and administer the array.
• <member_ip> — Each member IP Network address should have at least one
network interface on the same subnet as the group IP address.
• <member_mask> — Member Netmask combines with the member Ip
address to identify the subnet on which the network interface specified
resides. The default is 255.255.255.0
• <member_gateway> — Member Gateway network address is for the
device that connects the subnet and forward the network traffic beyond the
local network.
• —e — Enables to select existing or create new group for a member. The valid
values are:
– 0 — to create new group
– 1 — to use existing group
NOTE:
If —eis 0, then admin password is mandatory.
• <groupName> — Name of the group for administrative purpose. You can use
up to 64 alphanumeric characters and hyphens and the first character must be
a letter or a number.
• <group_ip> — Group IP and Network address for the group. The group IP
address is used for administrative and host access to volumes.
• <group_password> — Group Membership Management Password is
required when adding members to the group. The password must have 3 to 16
alphanumeric characters and is case-sensitive.
• <admin_password> — Group Administration Password to set admin
password when creating new group and will override the factory-set
password.
grpadmin is the default grpadmin account. The password must have
3 to 16 alphanumeric characters and is case-sensitive.
• —f — The valid values are
A or B . Select Fabric to be used for data I/O. Options
are:
– Fabric A (LOM port)
– Fabric B (Mezz port)
The default is Fabric B. If the option is not specified, then the configuration is
not done.
105