Quick Reference Guide

• racadm feature -a -c ExtendedStorage
• racadm feature -1 -c ExtendedStorage
• racadm feature -2 -c ExtendedStorage
• racadm feature -r -c ExtendedStorage
Input
• -s — Displays the status of active features.
• -d — Deactivates feature specified in -c option.
NOTE:
When the FlexAddress and FlexAddressPlus feature are active, deactivating one of them
results in deactivation of the other feature also.
• -a — Activates ExtendedStorage feature.
• -1 — Configures ExtendedStorage feature for standalone use.
• -2 — Configures ExtendedStorage feature for redundant use.
• -r — Reformats damaged/unformatted ExtendedStorage media.
•
CAUTION:
Using the -r switch deactivates the ExtendedStorage feature, if active; reformats the
SD card in the active CMC card slot; and may reboot the active CMC.
• -c — <featurename> must be one of the following:
• flexaddress (with -d)
• flexaddressplus (with -d) ExtendedStorage (with -a,-d,-1,-2,
or -r)
featurecard
Description Verifies proper SD card installation and displays the SD
card status.
This subcommand is applicable only for CMC.
To use this subcommand, you must have Chassis
Configuration Administrator
privilege.
Synopsis
racadm featurecard -s
Input -s — Lists active SD card features and SD card status.
Output
• No feature card inserted — Action:
Check the CMC to verify that the SD card was
properly inserted. In a redundant CMC
configuration, make sure the CMC with the SD
feature card installed is the active CMC and not
the standby CMC.
• The feature card inserted is
valid and contains the following
feature(s) FlexAddress: The
feature card is bound to this
chassis — Action: No action required.
• No features active on the chassis
—
Action
: Install the SD card into the CMC.
• The feature card inserted is
valid and contains the following
feature(s) FlexAddress: The
34