Quick Reference Guide

Input CMC only options:
• -m <
module > - Specifies the device to reset the configuration on < module >.
< module > must be one of the following values:
– chassis : default state if -m is not specified
– server-n, where
n = 1 to 16
– server-nx, where
n = 1 to 8; x = a to d (lower case)
– kvm
iDRAC only options:
• -f — Force resetcfg. If any VFlash partition creation or formatting is in progress
when this command is issued, iDRAC sends back a warning message indicating
the same. You can perform a force reset using this option.
Example
• Reset the configuration on iDRAC:
racadm racresetcfg
The RAC configuration has initiated restoration to factory defaults.
Please wait up to a minute for this process to complete before accessing the RAC
again.
• Reset the KVM configuration on CMC:
racadm racresetcfg -m kvm
The configuration has initiated restoration to factory defaults.
• Reset blade 8 configuration from CMC:
racadm racresetcfg -m server-8
The RAC configuration has initiated restoration to factory defaults.
Please wait up to a minute for this process to complete before accessing the RAC
again.
• Reset when vFlash Partition creation is in progress:
racadm racresetcfg
A vFlash SD card partition operation is in progress. Resetting the iDRAC may
corrupt the vFlash SD card. Use -f flag to force racresetcfg.
raid
Description Allows you to run commands to control RAID arrays.
This subcommand is applicable only for iDRAC.
To use this subcommand you must have Configure iDRAC permission.
Synopsis
racadm raid
Example
• Monitor Health of Storage root node
racadm raid get status
Storage Root Node Status : Ok
The above command retrieves the controllers keys, (FQDDs.)
98