User Manual

Installing 3.5–inch hard drive assembly

1 Insert the hard drive assembly into the slot on the computer until it clicks into place.

2 Close the front panel door.

3 Connect the SATA cable and the power cable to the connectors on the hard drive.

4 Install the:

a bezel

b cover

5 Follow the procedure in After working inside your computer.

Installing the 3.5–inch hard drive into the hard drive bracket

1 Flex the other side of the hard drive bracket, and align and insert the pins on the bracket into the hard drive.

2 Insert the hard drive into the hard drive bracket until it clicks into place.

3 Install the:

a hard drive assembly

b bezel

c cover

4 Follow the procedure in After working inside your computer.

Removing the 2.5–inch drive assembly

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a cover

b bezel

3 Open the front panel door.

4 To remove the drive assembly:

a Disconnect the drive assembly cables from the connectors on the drive [1].

b Press the blue tabs on both sides [2] and pull the drive assembly out of the computer [3].

Removing and installing components