User Manual

Installing system fan

1 Insert the grommets into the slots on the back of the computer.

2 Hold the system fan with the cable facing the bottom of the computer.

3 Align the grooves of the system fan with the grommets on the chassis wall.

4 Pass the grommets through the corresponding grooves on the system fan.

5 Stretch the grommets and slide the system fan toward the computer until it locks into place.

NOTE: Install the lower two grommets rst.

6 Secure the intrusion switch cable to the system fan with an adhesive tape.

7 Connect the system fan cable to the connector on the system board.

8 Close the front panel door.

9 Install the:

a intrusion switch

b bezel

c cover

10 Follow the procedure in After working inside your computer.

System board

Removing system board

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a cover

b bezel

3 Open the front panel door.

4 Remove the:

a heat sink assembly

b processor

c expansion card

d optional M.2 PCIe SSD

e SD card reader

f memory module

g VGA daughter board

5 Disconnect the optical drive and hard drive cables [1,2] from the connectors on the system board.

Removing and installing components