Setup Guide

Installation And Configuration

WARNING: Before performing the following procedure, review the safety instructions that came

with the system.

Unpacking A Rack System

Unpack your system and identify each item.

Installing The Rails And System In A Rack

Assemble the rails and install the system in the rack following the safety instructions and the rack

installation instructions provided with your system.

Figure 1. Installing the Rails and System in a Rack

Using The System Without A Rack

You can use the system without the server rack. When you are using the system without a rack, ensure

that you follow these guidelines:

• The system must be placed on a solid, stable surface that supports the entire system.

NOTE: The system must not be placed vertically.

• Do not place the system on the floor.

• Do not place anything on top of the system. The top panel may deflect under the weight and cause

damage to the system.

• Ensure adequate space around the system for proper ventilation.

• Ensure that the system is installed under the recommended temperature conditions as stated in the

Technical Specification – Environmental Section of this document.

CAUTION: Failure to follow these guidelines may result in damage to the system or physical

injury.