Users Guide
Table Of Contents
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Installing and Uninstalling
- Chapter 3: Configuration
- 3.1 FC Driver Configuration
- 3.2 vPort Configuration
- 3.3 FC Driver Performance Tuning
- Chapter 4: Configuring NVMe over FC
- Chapter 5: Troubleshooting
- Appendix A: FCP Driver BlockGuard Functionality
- Appendix B: Configuring NVMe over FC on a Target
- Appendix C: Native NVMe Multipathing
- Appendix D: Trunking Support
- Appendix E: FC-SP-2 Authentication (DH-CHAP) Support
- Appendix F: ARM Support
Broadcom DRVLin-UG128-100
96
Emulex Drivers for Linux User Guide
2605: lpfc_dump_static_vport: memory allocation failed
Failed to allocate mailbox memory.
Data: None
Severity: Error
Log: LOG_MBOX
Action: None required.
2606: No NPIV Fabric support
No NPIV Fabric support.
Data: None
Severity: Error
Log: LOG_ELS
Action: None required.
2607: Failed to allocate init_vpi mailbox
Failed to allocate the INIT_VPI mailbox command.
Data: None
Severity: Error
Log: LOG_MBOX
Action: None required.
2608: Failed to issue Init VPI mailbox
The driver was unable to send an INIT_VPI mailbox command.
Data: None
Severity: Error
Log: LOG_MBOX
Action: None required.
2609: Init VPI mailbox failed <u.mb.mbxStatus>
The INIT_VPI mailbox command failed.
Data: None
Severity: Error
Log: LOG_MBOX
Action: None required.
2610 - FCF (x%x) reached driver's book keeping dimension:x%x
FCF index exceeded maximum FCF table index.
Data: None
Severity: Error
LOG: LOG_FIP
Action: None required.
2611 - FLOGI failed on FCF (x%x), status:x%x/x%x, tmo:x%x, perform roundrobin FCF failover
FLOGI failed on FCF.
Data: None
Severity: Error
LOG: LOG_FIP | LOG_ELS
Action: None required.
Table 8: FC Error Log Messages and Their Descriptions (Continued)