Install Guide

EqualLogic FS7500 Installation and Setup

1 Before You Begin

Figure 2: Using an Electrostatic Wrist Strap

2. Fit the band closely around your wrist.

3. Connect the banana plug to ground, or attach the plug to the alligator clip and connect the clip to a grounded

device such as an ESD mat or the metal frame of a grounded piece of equipment.

Environmental Requirements

The location of the EqualLogic FS7500 hardware must meet the following environmental requirements:

• Only operate an enclosure from a power source with a voltage range of 100 to 240 VAC.

• Make sure each power source has sufficient electrical overload protection.

• In North America, connect the enclosure to a source of power with over-current protection provided by a

double pole 20A or less device (UL 489 circuit breakers). In Europe, the over-current protection must be

provided by a 20A or less device (IEC circuit breakers).

• Make sure there is sufficient space for air flow in front of and behind the hardware.

• Make sure the location is properly vented.

• Review the technical specifications in FS7500 Controller Technical Specifications on page 6 and FS7500

Backup Power Supply Technical Specifications on page 6 to make sure your environment supports its

requirements.