Install Guide

Figure 29: Removing the BPS Bezel
Turning On Power to a BPS Power Module
To turn on a BPS power module and verify that it is operational, see Figure 30 and follow these steps:
Figure 30: BPS Power Module
1. On the front of the power module, press and hold the power button for 0.5 seconds.
2. Examine the LED on the front of the power module above the power button.
If the LED shows a steady green light and an alarm is not audible, the power module is operational.
If the LED is not green or if you hear an alarm, see Table 9 and Table 10.
Note: To silence an audible alarm, press the power button for 0.5 seconds. If the condition continues, you will
hear the alarm again.
32
EqualLogic FS7500 Installation and Setup
3 Power Connections