Administrator Guide

ip access-list extended test
remark 4 XYZ
remark 5 this remark corresponds to permit any host 1.1.1.1
seq 5 permit ip any host 1.1.1.1
remark 9 ABC
remark 10 this remark corresponds to permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.2
seq 15 permit ip any host 1.1.1.3
seq 20 permit ip any host 1.1.1.4
Dell# end
Dell# resequence access-list ipv4 test 2 2
Dell# show running-config acl
!
ip access-list extended test
remark 2 XYZ
remark 4 this remark corresponds to permit any host 1.1.1.1
seq 4 permit ip any host 1.1.1.1
remark 6 this remark has no corresponding rule
remark 8 this remark corresponds to permit ip any host 1.1.1.2
seq 8 permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.3
seq 12 permit ip any host 1.1.1.4
Route Maps
Route maps are supported on Z9000 platform.
Similar to ACLs and prefix lists, route maps are composed of a series of commands that contain a
matching criterion and an action; however, route maps can change the packets meeting the criterion.
ACLs and prefix lists can only drop or forward the packet or traffic. Route maps process routes for route
redistribution. For example, a route map can be called to filter only specific routes and to add a metric.
Route maps also have an “implicit deny.” Unlike ACLs and prefix lists; however, where the packet or traffic
is dropped, in route maps, if a route does not match any of the route map conditions, the route is not
redistributed.
Implementation Information
The Dell Networking OS implementation of route maps allows route maps with the no match or no set
commands. When there is no match command, all traffic matches the route map and the set command
applies.
Important Points to Remember
• For route-maps with more than one match clause:
– Two or more match clauses within the same route-map sequence have the same match
commands (though the values are different), matching a packet against these clauses is a logical
OR operation.
– Two or more match clauses within the same route-map sequence have different match
commands, matching a packet against these clauses is a logical AND operation.
• If no match is found in a route-map sequence, the process moves to the next route-map sequence
until a match is found, or there are no more sequences.
• When a match is found, the packet is forwarded and no more route-map sequences are processed.
– If a continue clause is included in the route-map sequence, the next or a specified route-map
sequence is processed after a match is found.
Access Control Lists (ACLs)
115