Administrator Guide

CAM Allocation Setting
vrfv4Acl 0
Openflow 0
fedgovacl 0
The following additional CAM allocation settings are supported on the S6000, S4810 or S4820T
platforms only.
Table 9. Additional Default CAM Allocation Settings
Additional CAM Allocation Setting
FCoE ACL (fcoeacl) 0
ISCSI Opt ACL (iscsioptacl) 0
The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other
profile allocations can use either even or odd numbered ranges.
You must save the new CAM settings to the startup-config (write-mem or copy run start) then
reload the system for the new settings to take effect.
CAM Allocation for Ingress
Use the cam-acl-egress command to allocate the space for egress L2, IPV4 and IPV6 ACL. The total
number of available FP blocks is 4. Allocate atleast one group of L2ACL and IPV4 ACL.
Dell(conf)#do show cam-acl-egress
-- Chassis Egress Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
-- Stack unit 7 --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
Dell(conf)#
1. Select a cam-acl action.
CONFIGURATION mode
cam-acl [default | l2acl]
230
Content Addressable Memory (CAM)